Subversion Repositories HelenOS

Rev

Rev 1097 | Rev 1102 | Go to most recent revision | Blame | Compare with Previous | Last modification | View Log | Download | RSS feed

#
# Copyright (C) 2003-2004 Jakub Jermar
# All rights reserved.
#
# Redistribution and use in source and binary forms, with or without
# modification, are permitted provided that the following conditions
# are met:
#
# - Redistributions of source code must retain the above copyright
#   notice, this list of conditions and the following disclaimer.
# - Redistributions in binary form must reproduce the above copyright
#   notice, this list of conditions and the following disclaimer in the
#   documentation and/or other materials provided with the distribution.
# - The name of the author may not be used to endorse or promote products
#   derived from this software without specific prior written permission.
#
# THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
# IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
# OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
# IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
# INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
# NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
# DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
# THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
# (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
# THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
#

#include <arch/asm/regname.h>
#include <arch/mm/page.h>
#include <arch/asm/boot.h>
#include <arch/context_offset.h>
    
.text

.set noat
.set noreorder
.set nomacro

.global kernel_image_start
.global tlb_refill_entry
.global cache_error_entry
.global exception_entry
.global userspace_asm

# Which status bits should are thread-local
#define REG_SAVE_MASK 0x1f # KSU(UM), EXL, ERL, IE
    
# Save registers to space defined by \r
# We will change status: Disable ERL,EXL,UM,IE
# These changes will be automatically reversed in REGISTER_LOAD
.macro REGISTERS_STORE_AND_EXC_RESET r
    sw $at,EOFFSET_AT(\r)
    sw $v0,EOFFSET_V0(\r)
    sw $v1,EOFFSET_V1(\r)
    sw $a0,EOFFSET_A0(\r)
    sw $a1,EOFFSET_A1(\r)
    sw $a2,EOFFSET_A2(\r)
    sw $a3,EOFFSET_A3(\r)
    sw $t0,EOFFSET_T0(\r)
    sw $t1,EOFFSET_T1(\r)
    sw $t2,EOFFSET_T2(\r)
    sw $t3,EOFFSET_T3(\r)
    sw $t4,EOFFSET_T4(\r)
    sw $t5,EOFFSET_T5(\r)
    sw $t6,EOFFSET_T6(\r)
    sw $t7,EOFFSET_T7(\r)
    sw $t8,EOFFSET_T8(\r)
    sw $t9,EOFFSET_T9(\r)

    mflo $at
    sw $at, EOFFSET_LO(\r)
    mfhi $at
    sw $at, EOFFSET_HI(\r)
    
#ifdef CONFIG_DEBUG_ALLREGS 
    sw $s0,EOFFSET_S0(\r)
    sw $s1,EOFFSET_S1(\r)
    sw $s2,EOFFSET_S2(\r)
    sw $s3,EOFFSET_S3(\r)
    sw $s4,EOFFSET_S4(\r)
    sw $s5,EOFFSET_S5(\r)
    sw $s6,EOFFSET_S6(\r)
    sw $s7,EOFFSET_S7(\r)
    sw $s8,EOFFSET_S8(\r)
#endif
    
    sw $gp,EOFFSET_GP(\r)
    sw $ra,EOFFSET_RA(\r)
    sw $sp,EOFFSET_SP(\r)

    mfc0 $t0, $status
    mfc0 $t1, $epc
    
    and $t2, $t0, REG_SAVE_MASK  # Save only KSU,EXL,ERL,IE
    li $t3, ~(0x1f)
    and $t0, $t0, $t3           # Clear KSU,EXL,ERL,IE
    
    sw $t2,EOFFSET_STATUS(\r)
    sw $t1,EOFFSET_EPC(\r)
    mtc0 $t0, $status
.endm

.macro REGISTERS_LOAD r
    # Update only UM,EXR,IE from status, the rest
    # is controlled by OS and not bound to task
    mfc0 $t0, $status
    lw $t1,EOFFSET_STATUS(\r)

    li $t2, ~REG_SAVE_MASK    # Mask UM,EXL,ERL,IE
    and $t0, $t0, $t2
    
    or $t0, $t0, $t1   # Copy UM,EXL,ERL,IE from saved status
    mtc0 $t0, $status
    
    lw $v0,EOFFSET_V0(\r)
    lw $v1,EOFFSET_V1(\r)
    lw $a0,EOFFSET_A0(\r)
    lw $a1,EOFFSET_A1(\r)
    lw $a2,EOFFSET_A2(\r)
    lw $a3,EOFFSET_A3(\r)
    lw $t0,EOFFSET_T0(\r)
    lw $t1,EOFFSET_T1(\r)
    lw $t2,EOFFSET_T2(\r)
    lw $t3,EOFFSET_T3(\r)
    lw $t4,EOFFSET_T4(\r)
    lw $t5,EOFFSET_T5(\r)
    lw $t6,EOFFSET_T6(\r)
    lw $t7,EOFFSET_T7(\r)
    lw $t8,EOFFSET_T8(\r)
    lw $t9,EOFFSET_T9(\r)
    
#ifdef CONFIG_DEBUG_ALLREGS 
    lw $s0,EOFFSET_S0(\r)
    lw $s1,EOFFSET_S1(\r)
    lw $s2,EOFFSET_S2(\r)
    lw $s3,EOFFSET_S3(\r)
    lw $s4,EOFFSET_S4(\r)
    lw $s5,EOFFSET_S5(\r)
    lw $s6,EOFFSET_S6(\r)
    lw $s7,EOFFSET_S7(\r)
    lw $s8,EOFFSET_S8(\r)
#endif
    lw $gp,EOFFSET_GP(\r)
    lw $ra,EOFFSET_RA(\r)
    
    lw $at,EOFFSET_LO(\r)
    mtlo $at
    lw $at,EOFFSET_HI(\r)
    mthi $at

    lw $at,EOFFSET_EPC(\r)
    mtc0 $at, $epc
    
    lw $at,EOFFSET_AT(\r)
    lw $sp,EOFFSET_SP(\r)
.endm

# Move kernel stack pointer address to register K0
# - if we are in user mode, load the appropriate stack
# address
.macro KERNEL_STACK_TO_K0
    # If we are in user mode
    mfc0 $k0, $status
    andi $k0, 0x10
    
    beq $k0, $0, 1f
    add $k0, $sp, 0
    
    # Move $k0 pointer to kernel stack
    lui $k0, %hi(supervisor_sp)
    ori $k0, $k0, %lo(supervisor_sp)
    # Move $k0 (superveisor_sp)
    lw $k0, 0($k0)
1:      
.endm
        
.org 0x0
kernel_image_start:
    /* Load temporary stack */
    lui $sp, %hi(end_stack)
    ori $sp, $sp, %lo(end_stack)

    /* Not sure about this, but might be needed for PIC code???? */
    lui $gp, 0x8000
    
    jal main_bsp
    nop


    .space TEMP_STACK_SIZE
end_stack:

tlb_refill_entry:
    j tlb_refill_handler
    nop

cache_error_entry:
    j cache_error_handler
    nop

exception_entry:
    j exception_handler
    nop 

    
    
exception_handler:
    KERNEL_STACK_TO_K0
    
    mfc0 $k1, $cause
    sub $k0, REGISTER_SPACE
    
    sra $k1, $k1, 0x2     # cp0_exc_cause() part 1
    andi $k1, $k1, 0x1f   # cp0_exc_cause() part 2
    sub $k1, 8            # 8=SYSCALL
    
    beqz $k1, syscall_shortcut
    add $k1, 8            # Revert $k1 back to correct exc number
    
    REGISTERS_STORE_AND_EXC_RESET $k0
    move $sp, $k0
    
    move $a1, $sp
    jal exc_dispatch      # exc_dispatch(excno, register_space)
    move $a0, $k1

    REGISTERS_LOAD $sp
    # The $sp is automatically restored to former value
    eret

# it seems that mips reserves some space on stack for varfuncs???
#define SS_ARG4   16
#define SS_SP     20
#define SS_STATUS 24
#define SS_EPC    28
syscall_shortcut:
    # We have a lot of space on the stack, with free use
    sw $sp, SS_SP($k0)
    move $sp, $k0

    mfc0 $t1, $epc
    mfc0 $t0, $status
    sw $t1,SS_EPC($sp)  # Save EPC
    
    and $t2, $t0, REG_SAVE_MASK # Save only KSU,EXL,ERL,IE
    li $t3, ~(0x1f)
    and $t0, $t0, $t3           # Clear KSU,EXL,ERL
    ori $t0, $t0, 0x1           # Set IE

    sw $t2,SS_STATUS($sp)
    mtc0 $t0, $status

    jal syscall_handler
    sw $v0, SS_ARG4($sp)        # save v0 - arg4 to stack

    # restore epc+4
    lw $t0,SS_EPC($sp)
    addi $t0, $t0, 4
    mtc0 $t0, $epc
    
    # restore status
    mfc0 $t0, $status
    lw $t1,SS_STATUS($sp)

    li $t2, ~REG_SAVE_MASK      # Mask UM,EXL,ERL,IE
    and $t0, $t0, $t2
    or $t0, $t0, $t1            # Copy UM,EXL,ERL,IE from saved status
    mtc0 $t0, $status
            
    lw $sp,SS_SP($sp) # restore sp
    
    eret
    
tlb_refill_handler:
    KERNEL_STACK_TO_K0
    sub $k0, REGISTER_SPACE
    REGISTERS_STORE_AND_EXC_RESET $k0
    add $sp, $k0, 0

    add $a0, $sp, 0 
    jal tlb_refill /* tlb_refill(register_space) */
    nop

    REGISTERS_LOAD $sp

    eret

cache_error_handler:
    KERNEL_STACK_TO_K0
    sub $sp, REGISTER_SPACE
    REGISTERS_STORE_AND_EXC_RESET $sp
    add $sp, $k0, 0

    jal cache_error
    nop

    REGISTERS_LOAD $sp

    eret

userspace_asm:
    add $sp, $a0, 0
    add $v0, $a1, 0
    eret